Thanks Steve for reaching out-- I suppose what I am asking is rather specific to analog controllers like the Obey 40.
I have a few questions, but I will start with this:
1. I have two sets of Up-lights (2 colors basically). One is on DMX channel 1, the next on 17.
When I click Fixture 1, and manually set a color, it's all good. Then I click off of 1, and click Fixture 2, and the fixture 1 goes off (resets). Why does it do this? The only work around is to go into program mode, even though I am not creating scenes. It seems to hold Figure's 1 settings, even when I click off of it, to program fixture 2.
So I have been doing this, but what sucks is if I want to go back to fixture 1, I am essentially starting over as soon as I move the slider. So if I want to fine tune an Amber, I essentially and resetting the R,G from start, not where I left off, before I went to fixture 2.
Again, this is probably not clear, and if someone is a DMX guy, I would appreciate a call.