Stacking Subs?

To many ads? Support ODJT and see no ads!

HiDefDJ

New DJ
Aug 13, 2006
2,150
0
47
I currently use the powered 15 RCF sub.

I was also thinking about picking up a Yorky LS800p.

While it's physically possible to stack the RCF on top of the Yorky, is it wise to do so?

For example, here's a crappy pic of my setup. You can see I place the RCF right in the middle of my DJ booth. I would place the Yorky where the RCF is and place the RCF on top.

vbpgimage.php




Good? Bad? In laymen's terms please.
 
I would use one or the other, not both. Different subwoofers usually don't play well together in the same frequency range It would also be a bad idea to raise the ART705 to that height, since it would result in boundary cancellation of the sub's output right below 80 Hz.

This might work if you crossed over from one sub to the other above 80 Hz, but the Yorkville does not give you a highpass output and the two subs are so different that they would be totally out of phase with each other at the crossover point, which would require dsp to correct.

I'd just use the Yorkie if the situation called for that much bass.
 
That's always been my problem. I work by myself and wanted a sub(s) that could do weddings and school gigs. I was going to get 2 ls800's but didn't want to carry one around for regular gigs, hence the RCF.

How would 2 RCF's coupled compare to 1 Yorky?
 
A. When did you get an RCF sub?

B. Audiopyle is right. Mixing the two is a bad idea, just pick up another RCF

C. My RCF is bigger than yours!!! :headbang:
 
You don't want to mix subs with different sizes (10", 12", 15", 18")... you will get cancellation. You want to try and keep them all the same size. If you put a 10" next to an 18" the 18" will cancel out most of the bass from the 10"
 
I used 2 JBL JRX 118 with 2 Mackie SWA1501's with my Turbosound TXD121's Sunday night, just for fun. On a normal ovbervation this was overkill, and not something I would normally do.

It souned fantastic. The 15"s provided the bumps and hits and the 18"s the rumble and oscillation. So Cam in your experiment did you still find it wasnt loud enough?
 
I used 2 JBL JRX 118 with 2 Mackie SWA1501's with my Turbosound TXD121's Sunday night, just for fun. On a normal ovbervation this was overkill, and not something I would normally do.

It souned fantastic. The 15"s provided the bumps and hits and the 18"s the rumble and oscillation.

some think the subs would cancel out.....did you notice?

I'm sure learning a lot on this thread.
 
Basic,

You actually have a great opportunity here to try something that will be great for your sound. Cross the 18" subs at 90 hertz, stack the 15" on top and set cross points at 180 and 90, mids crossed at 1500 and 180, highs at 1500 +. You certainly won't hurt your sound at all this way.
 
Steve Miller said:
You actually have a great opportunity here to try something that will be great for your sound. Cross the 18" subs at 90 hertz, stack the 15" on top and set cross points at 180 and 90, mids crossed at 1500 and 180, highs at 1500 +. You certainly won't hurt your sound at all this way.
...but he'll need an active crossover.
 
Too many want to do things the easy way...

Everyone wants to plug 'n' play right out of the box. Setting an active crossover (and getting good tone from the system) isn't as easy.

The easy way isn't necessarily the best way. If good sound was easy, anyone could do it. :)
 
Rox,

Yes sometimes I forget I was raised on the old method

Hey Fred my buddy, thanks for putting up my Avatar!