Problem with Mixer

To many ads? Support ODJT and see no ads!
SO....

I took the Sub aout again (Small Party)
Had some time to Dink around with the Gear prior to Guests Arrival
After many Cable Configurations
I have come to the conclusion that the Issue is not with the Mixer!

It was my Patch Bay on the Side of my Gatro Case
(I had checked all the Colour (Canadian spelling) Cables inside the wires
and all looked okay) when I used the Patch Bay I Lost Base, When I went Directly from Mixer all was Fine. I did try this Earlier (Previous Posts indicate this) I also had an Issue with a Broken XLR Cable.

SO, all is Good & I am HAPPY!!!
 
Very glad you got the problem sorted out EK.

When trying to explain a situation it is helpful to describe/detail ALL the interconnects. We might have been able to get you there a bit sooner as we didn't know about the patch panel. It would have been suspect.
 
Very glad you got the problem sorted out EK.

When trying to explain a situation it is helpful to describe/detail ALL the interconnects. We might have been able to get you there a bit sooner as we
didn't know about the patch panel. It would have been suspect.

Honestly, I though I Did! When I was describing the Configurations (I checked & I Didn't mention it) Sorry
 
No Prob!

Hey No problem, your honesty is appreciated.

An inexpensive DMM (Digital Multi Meter) will help find problems like that quickly. A simply continuity checker will work as well as long as you know your cables are out of any circuit (disconnected from electronics). In most cases a check light / continuity checker will not do any harm but in rare circumstances it possibly could.