Ok another Sub

To many ads? Support ODJT and see no ads!
Cam,

I think your sub has some issues or your gains are out of whack.

There are specific unity gain points on each piece of gear giving a specific voltage at that point ie .75, 1.0, 1.4, 1.75 etc. So an amp with a unity gain at .75 volts and a board which reaches unity at 1.75 there will be issues as to clipping.
 
Why are you using a crossover? The Mackie subs have one built in. You go from mixer into subs into tops. Have you tried this?

Maybe something in the chain is sending too hot a feed or maybe spikes. Start basic and then add the other stuff in.

Great point Kev. I run a powered sub with passive tops. I come out of the sub output on the back of my mixer directly to the sub and ch1 & ch2 outputs go to my amp for the tops. I don't know if the mackies have this switch on the back, but make sure you send a line signal not a speaker level signal.
 
It has never came on with any of the SWA1501's I have owned.
At All? Even when running full tilt? If that is the case then something sounds horribly wrong with the protection circuitry which keeps the sub from a) overheating b) clipping... i would highly suggest you try to get the light to come on, to see if that is the case... if not, tell mackie that their product seems to be malfunctioning.

-------
I hope mackie turns their crap around, they did have reliable products. My next system will be Yorkvilles when that time comes. Otherwise for passive JBL always has a special place in my heart.
 
I use a crossover to change the crossover point on th Mackie. I believe the crossover point of the mackie's internal crossover is 150hz. I change it to 80hz. In the past I have used the internal crossover but had the same results and to me it sounds very muddy.