Advice on what lights to get

To many ads? Support ODJT and see no ads!
djoutlaw said:
Just did two events this weekend with the quad phase and it worked great and was bright enough--awsome light. However, my two color scans weren't used due to the fact that once I placed them on the botton truss they would tilt downward eventhough I had tightened them as tight as possible. To correct this I'm going to have to move some lights around so I can place them on the top truss bar so if they do tilt downward the bars between the top and bottom truss will stop them from tilting further.
Click to expand...

If your scanners are like mine I have the same problem... so what I did was used O-Clamps and clampted them to the Truss Stand itself instead of the truss...the stand gives my ADJ HP250 Scanners support so they don't tilt down...

Go to my website there is a photoshow there and the first picture illistrates what I mean. www.totalimpactdjs.com
 
jokerswild said:
If your scanners are like mine I have the same problem... so what I did was used O-Clamps and clampted them to the Truss Stand itself instead of the truss...the stand gives my ADJ HP250 Scanners support so they don't tilt down...

Go to my website there is a photoshow there and the first picture illistrates what I mean. www.totalimpactdjs.com
Click to expand...

I like your idea I don't know why I didn't think of that at the time--I was thinking of placing them on the speaker pole but I wanted them linked and didn't have cable long enough to do so. Plus, I felt the speaker pole wasn't high enough so I scratch that plan and tried to place them on the truss then ran into the slippage problem. I did purchase two O-clamps for the lights so I'm good there.

I like your tour x setup--I have the same--by the way what amp are you using to run it?
 
djoutlaw said:
I like your idea I don't know why I didn't think of that at the time--I was thinking of placing them on the speaker pole but I wanted them linked and didn't have cable long enough to do so. Plus, I felt the speaker pole wasn't high enough so I scratch that plan and tried to place them on the truss then ran into the slippage problem. I did purchase two O-clamps for the lights so I'm good there.

I like your tour x setup--I have the same--by the way what amp are you using to run it?
Click to expand...

I'm running two amps.... I power the tops with a QSC RMX2450 and the subs with an EV Q99 All equed and controlled by a DRPA
 
You must log in or register to reply here.
Top Bottom
Back