Revo Roll & Revo Scan Review...
Packaging was excellent. There was a large piece of foam at either end of the unit, so that there was 3 inches of space around the unit inside the box. One of my boxes had a gouge in it that didn't affect the fixture at all.
When I removed them from the box, I was amazed at the light weight. The case was extruded metal construction and felt very sturdy for being so light. I wished they had been equiped with mirror covers... I suspect mirrors will get broken in mobile applications without protection.
Both units will stand on a flat surface without concern for fans or cords, since the controls and power cord come out of the top. A base support of some kind might be necessary if there was a desire to use them on a table or speaker, for example. The footprint was small, and knocking it over might be an issue if used this way. The mounting bracket was very small on the back, but was adiquate for most applications.
The instruction book was lacking. The unit was said to "automatically" go into sound active mode , it didn't at first... but then I discovered that there was a cycle period... and THEN it activated. It took about 30 seconds, so hooking it to a co-pilot was out of the question for a quick start.
In order to use either fixture without a DMX signal, you HAVE to purchase a push button remote for "On" or "Off" of the LEDS. I left the unit "On" all night (no cycle period) and it was just fine.
One problem was the display didn't match the manual for each mode. The instruction manual gave you images of what each mode should look like on the display, but that's not what they looked like. A simple re-write would fix the manual. I was impressed at the modes available. You chould swap pan and tilt to be 180 degrees out with the master, "stand alone" "master/slave" etc... very cool.
I activated the Scan and watched all of the patterns. It functioned well and moved nicely. The stepper motor was smooth and had lots of range. I liked the patterns.
I then started to play with the "Roll"... what a difference. It acted MUCH more like a barrel scanner. Keep in mind, that these units are not "true" scanners. They are "Moon flower" effects with X / Y axis mirrors.
Neither unit was able to RGB color mix (like an LED par can), but the effect was very nice anyhow. The display was just like the Revo series fixtures. And, unless you have some smoke in the air, or a surface for the unit to shine on, the effect is remarkably reduced. The LED patterns were similar to a Revo I. The "Roll" fixture multiplied this pattern via the barrel mirror, and made it look much more like a Revo III that moved. Again, very cool.
Both units are 4 channel, and neither could color mix, or utilize gobos. There is a "strobe" feature on both. Due to LED function, you can't dim either unit, and I don't think you'd want to. The claim of 250 watts wasn't realistic. I'd estimate 150 watts from it's beam appearance.
For a beginner DJ, these units are a great way to begin your DMX carreer, or add a few to you current show. Used either with the push button controller, or DMX controller , these are "nice" units for the price (maybe a "few" dollars too high).
YouTube - Revo Roll
YouTube - Revo Roll at gig 1
YouTube - Revo Roll 2 at gig