My mic is SO MUCH hotter than my line level stuff...

To many ads? Support ODJT and see no ads!

Papa Deuce

Mac Daddy DJ
Aug 8, 2006
19,843
594
64
Valley Forge Area
I had my SM 57 plugged into my CD MIX2... using XLR to 1/4" ( that's the input for the Mix 2 )

To get the volume I wanted on my decks, I had them pretty wide open. For my mic, I could barely crack the knob... It sounded clean and loud enough, but I'm telling you I could just barely crack it open.

Is this normal?
 
I had my SM 57 plugged into my CD MIX2... using XLR to 1/4" ( that's the input for the Mix 2 )

To get the volume I wanted on my decks, I had them pretty wide open. For my mic, I could barely crack the knob... It sounded clean and loud enough, but I'm telling you I could just barely crack it open.

Is this normal?

The SM57 is actually an instrumental mic and is hot to begin with...
 
why not use it on an input with XLR. 1/4" is not really designed for Mics. Sure it works, but what your describing is really not a good gain structure.


CD Mix 2.... only 1/4" inputs. ( as I recall )
 
I don't use the mixer you have but I have used the Mic Pre-Amp The "Art MP" which you can cut back the gain prior to it going to your mixer...However when it comes to the wired mic's I use the SM 58....with no problems........Found them on E-Bay $90 a piece brand new........(both with on/off switch on mic itself)
 
A good pre-amp would be something to consider, heck even one of those cheap behringer mixers with phantom power & a few line level inputs. I understand the use of 'what is provided' on your mixer, But I imagine it is for those "karaoke" cheap-o mics you can pick up at a dollar store.
 
I am unfamiliar with this unit. Are the 1/4" mic jacks TRS? If so, there should be no problem patching an XLR in via a "bullet" connector.