I've been using my new front board the past couple of weeks. Interested to get some feedback on it. The unit is 2' high with a 2" center hinge piece (so it folds flat). The middle 2 sections are 2' wide with 15" width on the outer panels. I covered it in a fake alligator covering. On a standard table it brings the top of the unit to chest height (I'm short). You can sit down and hide behind it or stand and see everything. It also covers my gear completely.
By the way, for lighting this week (we were in a 4k sq ft barn) I used a Martin Acrobat, mounted under each K10 top and I put up a separate tripod with a Chauvet Intimidator 255 mover. In this facility, the tops/lights were about 20 feet spread, on either side of a huge fireplace. This setup was not DMX but it was very effective. The beams from the movers punched all the way to the back wall (80-100 feet) and the Acrobats gave a really nice splatter, all around the dance floor. This coming week for my Sweet16 I'm planning to use the same thing but will be adding 4 flat mirror scanners, which are DMXed. I'm intending to hang these from a 15ft mini-truss section with a projector filling the space in between the uprights.
By the way, for lighting this week (we were in a 4k sq ft barn) I used a Martin Acrobat, mounted under each K10 top and I put up a separate tripod with a Chauvet Intimidator 255 mover. In this facility, the tops/lights were about 20 feet spread, on either side of a huge fireplace. This setup was not DMX but it was very effective. The beams from the movers punched all the way to the back wall (80-100 feet) and the Acrobats gave a really nice splatter, all around the dance floor. This coming week for my Sweet16 I'm planning to use the same thing but will be adding 4 flat mirror scanners, which are DMXed. I'm intending to hang these from a 15ft mini-truss section with a projector filling the space in between the uprights.