Well... I'd like to propose a scenario:
If you don't wish to open your power amps and clean the dirt outta the fan and heat sinks, be prepared for the possibility of thermal shutdown.
Warranty, schmarranty. A warranty ain't nothin' but a piece of paper... and a piece of paper isn't gonna keep these cabs a' thumpin' when it's 100 degrees F out. If an amp goes thermal in the middle of a show due to lack of maintenance, are you gonna pull out that warranty paper and connect it up to your speaker systems?
Personal experience: We bought a used DCM2000 amp on eBay some years ago. The seller was honest about it... said it was going thermal on him and he didn't know how to fix it. Upon receipt of the amp I powered it up with a pair of dual 15s, low level. It seemed to work fine. I noticed that the cooling fan wasn't moving air, though. Well, this could explain the thermal cutout, I figured. Carvin sells replacement fan assemblies for these amps anyhow...
Then I did as Dan suggests ~ I removed the cover for a looksee.
Folks, the area around that cooling fan looked like a huge rat's nest. There was wad of dirt and dust nearly the size of my fist blocking the fan. I started to pull the stuff loose and then went to get a trash bag. I actually picked that amp up, turned it upside down over a trash can and pulled that wad of crap outta there.
Disclaimer: If you're not completely sure of what you're doing, don't try the following at home.
I ensured that the fan was clear and the blade turned freely. Then I powered the amp up on the bench. The fan started up and blew a cloud of dust in the room. (Aw f**k... koff, koff. After 30 years of doing this stuff you'd think I'd know better...)
Opened the utility room door to let the place air out. Stood outside and had a cigarette.
Powered down, unplugged the AC supply cord and proceeded to thoroughly clean that amp 'til it was as clean as a new one inside. I used an old toothbrush dipped in isopropyl to clean the power supply heatsinks, circuit boards and other areas (everything was caked with crap).
I removed the fan assembly and cleaned it thoroughly as well. The blade and venturi had a heavy layer of goo that required a good scrubbing.
We've been running that amp in our system ever since with no troubles whatsoever. It has had the he-double L worked out of it in extreme heat outdoors and run full-bore.
I guess what I'm trying to say here is... yes, cleaning your power amps is a very important part of equipment preventive maintenance. Just cleaning the ouside of the fan housing isn't gonna do it, sorry. The real dirt is inside.
Hope it helps.