How do you Connect Multiple Speakers?

To many ads? Support ODJT and see no ads!

DJ Gray

New DJ
Oct 25, 2006
2,099
2
18
I have 4 JBL EONS powered speakers that I need to use for an event. I will run these off my DBX Crossover. I will have (2) on the left (2) on the right. What do I need to know have this set-up properly?
 
That's all there is to it Gray. Just loop out from one and into the next using shielded mic cable. Check that switch as Jeremiah said. No sweat. :)

Ben

That's what I thought it was, and what I have done when testing, just didn't know if I had to adjust the DMX223XL crossover for the fact that I have 4 tops now, and only (2) subs? Or is it still adjusted to the ear?
 
Oh...

Ben correct me if I'm wrong... but can't you plug in as many active speakers in a chain as you want?
 
You can daisy chain as many active speakers as you want. Just make sure you are using good quality XLR cable.
 
The amount of signal loss is minuscule. You will not notice any difference, if any by daisy chaining, if so you can compensate for that by using the gain on the mackies.

Be sure to use a good XLR cable, you may wish to use a cable tester to verify continuity of ALL 3 pins, not having a ground or shield (pin 3) may induce ground loops and buzz into your system.
 
All of the above replies are correct. Yes, you do lose signal, but strength and quality... but yes, you can connect as many speakers as you are likely to connect.

Basically it boils down to this. Use a good, quality sheilded XLR cable and you are likely to be able to connect any REASONABLE number of speakers without any intelligible loss in signal strength or quality. Somebody with the ambition of the MythBusters would be able to test this to the breaking point, but frankly I doubt anyone on this board or any combination of the two have enough powered speakers to reach that point. LOL.

Ben
 
Be sure to use a good XLR cable, you may wish to use a cable tester to verify continuity of ALL 3 pins, not having a ground or shield (pin 3) may induce ground loops and buzz into your system.

Quick correction. The ground / sheild should be connected to pin 1 on an XLR. Pin 3 is the signal "cold" or "-".

Ben
 
Somebody with the ambition of the MythBusters would be able to test this to the breaking point, but frankly I doubt anyone on this board or any combination of the two have enough powered speakers to reach that point. LOL.

Ben


That sounds like a plan.
 
Quick correction. The ground / sheild should be connected to pin 1 on an XLR. Pin 3 is the signal "cold" or "-".

Ben
Whoops... It's been a while Ben, Looks like I need to assemble some more XLR's that are sitting on my desk.
 
anybody know what some switchcraft XLR ends may run? I'd like 6 female and 6 male

Jeremiah -

We carry lots of XLR connectors, including a switchcraft style that we sell either by the piece or in bulk. We do a lot of wholesale to other contractors, and I recall you saying something about installs you do. We should visit about that sometime. :)

Ben