DMX Relay Packs?

To many ads? Support ODJT and see no ads!

HiDefDJ

New DJ
Aug 13, 2006
2,150
0
47
I have a question about DMX relay packs. Say I plug some analog lights into a 4 channel realy pack like this.

dmx4_dimmerRelayPack.jpg


I assume I would be able to turn my analog lights on and off via this unit in my dmx chain, right? For example I have 2 pinspots on channel 1, a vertigo on channel 2, a black light on channel 3.... I would be able to turn these analong lights on and off from my dmx controller?
 
Relay pack or dimmer pack...

You can control any DMX fixture with a controller. If you are using a DMX dimmer pack, make sure you give the analog fixture the FULL signal (value at 255). You don't want to give a vertigo a 50% signal because you'd very quickly ruin the motors.

You CAN give a par can (pin spot) any signal. Light filaments are very capable of handling less signal without damage.
 
You can control any DMX fixture with a controller. If you are using a DMX dimmer pack, make sure you give the analog fixture the FULL signal (value at 255). You don't want to give a vertigo a 50% signal because you'd very quickly ruin the motors.

You CAN give a par can (pin spot) any signal. Light filaments are very capable of handling less signal without damage.

OK, so a 4 channel relay pack would allow me to control 4 seperate fixtures individually. Basically I would have for example a vertigo on dmx channel 1 and 255 would be on and 0 would be off. I would then have a a laser on channel 2 with the same thing. Channel 3 would have a blacklight and channel 4 would have anotehr vertigo. Then next in my dmx chain would be a novascan that I COULD start at DMX channel 5??
 
Sure... you could do that...

I personally, would start my Nova on "scanner" button #2 which starts with an address of 17 (leaving the rest of the channels on button one for more dimmer packs), but you COULD do it the way you suggested.

As far as "leaving" the "0" to off, you are a little bit confused (I think). The channel slider on the first four fixtures should be all the way "up" which has a value of 255. It's not an issue of leaving "0" to off.

Call me when you are ready to program and I'll talk you through it.