Rental Equipment Setup?

To many ads? Support ODJT and see no ads!
Aug 9, 2006
2,367
8
51
Phoenix, AZ
Renting some speakers for a Larger University Party

Looking at renting

2 - Turbosound (Model unkown) Dual 15" Passive
2 - 15" Active Subs

My Question for Setup

Can I go from Mixer out to Subs, then from Sub out to Amp, and from amp to Tops?
 
More information needed.

Do the sub cabs have a built-in active crossover with mid-high outs? If so, cool. If not, feed the subs from your mixer's sub out jack and the dually 15s full range from your amp fed from the mixer line out.

You may be lacking in vocal warmth with this scenario... but I'll leave it to you. :)
 
In all honsety the SWA1501's are not going to match up properly.

I'm guessing they are going to rent you Turbosound TXD-252's. Everything in the touring series is currently 3-way. Unless they are renting you sonething from the 80's

You will need min of 1000 watts at 4 ohms for the tops. Turbos can take some serious power I'd actually run 1400 to 1600 watts to each speaker. When we use 252's we power the pair with a Crown Macrotech 3600.

Mackie SWA1501's are only 500 watts, they will not produce enough bass to run with the tops.

We use TXD-252's for live sound and we use Turbosound Dual 18"s under them for bass. You may want to reconsider your choice of subs.
 
Still a bad match. See if they at least have some type of 18" to rent you.

The tops will over power the subs 2 to 3 times.
For a big dance the subs should be equal to 2x the power of the tops. At least that is how we set up.

How are you going to power the tops? You may want to Bi-amp them If you don't have a single amp big enough.


If you end up with the mackies. You will take your mixer out to the 2 mackies and then take the full range out to your amplifer powering the dual 15" Turbo's. Couple the 2 15"s together in the middle of your room to get and additional 2 to 5 dB spl.
 
Still a bad match. See if they at least have some type of 18" to rent you.

They do have the Mackie 18s

The tops will over power the subs 2 to 3 times.
For a big dance the subs should be equal to 2x the power of the tops. At least that is how we set up.

How are you going to power the tops? You may want to Bi-amp them If you don't have a single amp big enough.

they are providing the amp

If you end up with the mackies. You will take your mixer out to the 2 mackies and then take the full range out to your amplifer powering the dual 15" Turbo's. Couple the 2 15"s together in the middle of your room to get and additional 2 to 5 dB spl.

Couple the Subs together is what you are saying




I haven't confirmed anything yet with the rental guys
So I do have some play still
Do you think the Turbos would be fine on there own?
 
Final Configureation...
Just confimed with Client Max 200 Students

Taking

1 Mackie 18" Sub
2 Turbosound Dual 15"s
 
Final Configureation...
Just confimed with Client Max 200 Students

Taking

1 Mackie 18" Sub
2 Turbosound Dual 15"s

OK, my first concern would be the logistical size of the room being played. Is this a gymnasium type with hard angle surfaces and high ceilings? Or is this some other multi-use type room being used?

Since I don't have any first hand knowledge of the operating parameters of the Turbo dual 15's, I'm going to assume that they will fill the need for the venue being played.

How many amps will be used for the event? If at least two amps, is it possible to Bi-amp with an active crossover?
 
Size of Hall is would be about a 100ft x 250ft Room
Carpet Surrounding Dance Floor
High Ceilings
I will be on a 4ft Stage (on 100ft Side)
Accousticly I have done Multiple Parties (Weddings)
here with just 2 Single 15 Speakers on stage with plenty Sound


Will place the Dual 15s on Stage (One Amp Running Tops)
Sub centered on the Dance Floor (Active Speaker)


Now I have been told two separate things with regards to setup...

Console to Sub, Full range out to Amp to Tops
Console to Sub Mid/High out to Amp to Tops
 
Size of Hall is would be about a 100ft x 250ft Room
Carpet Surrounding Dance Floor
High Ceilings
I will be on a 4ft Stage (on 100ft Side)
Accousticly I have done Multiple Parties (Weddings)
here with just 2 Single 15 Speakers on stage with plenty Sound


Will place the Dual 15s on Stage (One Amp Running Tops)
Sub centered on the Dance Floor (Active Speaker)


Now I have been told two separate things with regards to setup...

Console to Sub, Full range out to Amp to Tops
Console to Sub Mid/High out to Amp to Tops

OK, now I'm a little confused -- if the sub is powered/active, why run anything but the line level to it from the board, or am I missing something in the translation?