SEX vs. DMX...`

To many ads? Support ODJT and see no ads!
G

Guest

Guest
I did that to see if I get more views of this thread... C'mon folks, write some responseses...

OK, so I hooked up my old XP-3's tonight at the club I work at and discovered one of them made a grinding noise when I tried to "pan".

Everything was fine when I tilted the head, but lots of grinding otherwise, and it never stopped or tracked to the same place twice.

My suspicion is the drive belt for the head. I'll take it down tomorrow and take it apart to see if that was it. I also noticed that there is a ribbed gear coming off the motor drive that has a set screw that holds it to the shaft. I'll check that too to see if it was loose.

In the meantime, I ordered a new drive belt from ADJ, just incase the ribs on the belt are destroyed (you have to take the entire head apart to change the belt). Has anyone had experience with an XP-3 and tell me if it's just the belt? I'll know more when I take it apart.

$4 bucks for the belt and $5 bucks for shipping... boy did they bend me over the couch on shipping a small rubber belt (should have only cost a buck to ship).

So, does anybody have an XP-3 they want to get rid of? I'd like a backup fixture in case this happens again.
 
I Know You Want Responses

C'mon folks, write some responseses...

Here goes:

I don't think DMX likes sex...at least, not with women.

Eh?

You asked for it!

:p
 
I know some woment that like DMX sex... all programed out so they know exactly what they are going to see...
 
I got it fixed...

I'm going to post a new thread on what was the problem.
 
Sorry,,, didn't mean to offend...

I use DJ Scan 250's. I don't get the chance to use them much here, but I do like what they do.

One day I will need to learn DMX..
 
Have you got three hours????

That's all you'll need to learn it after you hook up a few lights and read "the book".

I'm guessing that you'll have to read through the book (every page) two or three times while sitting at your controller, and you'll have it down pat.

There's no reason why everyone on the boards can't learn DMX in an afternoon.
 
and so what do you think is the most "user friendly" controller out there for those of us who have a hard time learning new tricks,,, you know, us old dawgs! :)
 
and so what do you think is the most "user friendly" controller out there for those of us who have a hard time learning new tricks,,, you know, us old dawgs! :)


I would say a Chauvet DMX 50 or 55. The 50 is discontinued, so you might be able to get a sweet deal on one if you look. Just make sure whatever controller you buy has a joystick, it will make programming those scanners much easier.