Feed back help

To many ads? Support ODJT and see no ads!

barry stamper

New DJ
Aug 16, 2006
1,613
0
58
West Virginia
My Father has a small Karaoke system he has two 15inck speakers on poles and two monitors that are jumped off the two main speakers. He is having feedback problems and I don't really know how to help him since I dont use monitors and this is not an issue for me, I suspect it has
something to do with the way he is running the monitors off the speakers (possible Here's your sign statement) any help would be great thanks all Barry:sqembarrassed: oh and one amp if that matters
 
does he have an eq unit? or eq on th mixer? what type of monitors? are they floor monitirs or mounted? How many mics?

If he has eq you can find the frequency and turn it down slowly until the feedback goes away. Also consider the placement of speakers, remember any time the mic is open to the face of the speaker you can expect feedback. Therefore the mic and performer should not have their back to an open speaker.

This is all I can tell you with out knowing more on the setup. Hope it helps.
 
Are the speakers all some distance away from the singer/microphone? If the speakers are placed to close together or directly infront or directly behind the person with the mic it could cause feed back. Have you tried moving the speakers around the singer and but not in direct alignment in any direction?
 
I use a method i've never seen discussed anywhere using a PC and Parametric EQ's. I've heard that it works for me because my sound card has really accurate A/D converters, but I think it should at least help in any enviroment.

Step 1 Download Spectrumlab here.

Step 2 set your audio recording source.
107114204939-Spectrum-Laboratory-V2.7-b12.png


107114205033-SpecLab-Configuration-and-Display-Control.png


Step 3 Plug in your mics, put one on a stand and create feedback. Yes you heard me, create feedback. Now look for a solid line to appear in the spectrumlab graph. Place the mouse pointer over it and you'll see numbers appear next to it.

107114205425-Spectrum-Laboratory-V2.7-b12.png


Now here you can see i'm showing feedback at or around 1.340878 kHz. At this point what you need is what's called a Parametric EQ on your mic. We use an EMU1820 sound card at the 7 Bamboo, but this method should work with any Parametric EQ, bandpass filter, etc.

Most filters do not work in the kHz range, most of them work in the Hz range. So you'll have to convert. It's simple, just move the decimal place over 3 digits.

1.340878 kilohertz = 1340.878 hertz

There ya go.. Easy right? Ok now onto setting your Parametric or Bandpass EQ.

Now the example below shows an EQ in Reaper Basically you just have to put the Hz value in, then adjust the width of the filter. The less width you use the better, you just want to target the offending feedback frequency, not the entire audio range of your system.
107114235921-FX-chain-for-track-1-__.png

And there you have it. My kick butt method for kicking feedback butt.

--toq