Big Don : I used the 502 system for a while (up to four 502A, two 502B with the Panaray EDSP).
Take the back of the 502B back plate/cover off. Drill a hole in the back of it and mount a female speak-on (or 1/4" phono) jack and attach a 2' - 3' section of 14 ga speaker wire.
Take an Ultimate Support speaker mount for the 802s. Screw it upside down firmly in the balanced center of the top of the 502B (middle, slightly to the rear of center). Drill a hole in the top of the 502B and the center of the upside down Ultimate Support mount large enough to snake the 14 ga speaker wire up through the hole. Attach a speak-on (or 1/4" phono) connector to the end of the wire.
Take the center section of an Ultimate Support stand and cut to about a 4 foot length (or what ever length that the combo would fit in the lowest ceilinged facility you play). Drill a hole in to top of the pole just below where the 502A bracket slide on it. Fish a wire through the pole, leaving enough length to connect with the jack inside the reversed support bracket as well as reaching the inputs of the 502A and add speak-on (or 1/4" phono) jacks to each end.
Now you can plug your amp outputs to the 502B and the 502A on the back of the 502B. No stands, no dangling wires, and a super clean look.
Kinda like this:
I've had and used JBLs, Peaveys, Altecs, Cerwins, FBTs, BOSE 302, 502s, 802 (Series II and III), MB4s, and the like. It's all equipment history that can stay that way.