System is so Bad I don't know what

To many ads? Support ODJT and see no ads!

DJ Cam

New DJ
Oct 20, 2006
3,927
0
48
Pittsburgh, PA
www.djcamonline.com
I ran into a system so bad I had to help the guy out.

Now this isn't a Mobile system, it's a perm install, where I bowl.

System:

12 to 16 Pyle Pro Audio Mains with 6 1/2" and a HF

4 Cerwin Vega 18" Subs

American Audio 3000 Amplifier

2 Gemini 1400 Amplifiers

Pyle Pro Audio 3 way Crossover.

VocoPro Mixer

Dual Deck VocoPro Dual cd/cd+g player.

The sound is so bad I can not stand it, so I talked to the owner and he let me back to check things out.

I walk back:

Good Nothing is Clipping was my 1st thought after what a pile of junk. Ok the eq on the mixer is set to the max on everything. I set an EQ curve, and fixed the gain on everything. It helped, the equipment was like gee thanks. Everything still sounded like poop. I changed the crossover sending only 100hz and down to the subs. They were at 1k. I couldn't do anything for the mid and the high because the speakers used should be on a 2 way crossover. So after a few min no longer were the subs being used as almost a full range speaker, but everything still sounded like crap.

I told the owner I would come back during the day and see if I could be anymore help to the system, but I doubt I could do anything. I think there are blown speakers, and he is clueless how bad everything sounds. They have the smallest Cosmic Bowling crowd in the area. I think with a bumpin new system that could change. I don't sell equipment but I would love to tell this guy he need the equipment and sell him a new system.

Problem #1 The speakers are Pyle Pro Audio.
With 4 Cerwin Vega 18" subs.

Problem #2 The system is set up on a 3 way crossover there are 6 1/2" with a Hf and Subs.

Problem #3 There are 6 or more speakers connected to each amplifier. Now if the speakers are 16 ohm (which is possible) the amp should be ok.

Problem #4 I think a number of the speakers are shot.

So, on that note. What would you put in a 20 lane bowing alley. Think easy install and reasonable pricing.

I'm thinking 8 Eons a 4 of Some kind of powered flyable 18" JBL sub. Im guessing JBL JRX118sp. $6400 without cables.

Or 16 RCF MONITOR-44T 5" and 4 RCF Powered 15" Subs. $6200 but would use existing amps.

Ideas?
 
Even the best gear will sound pretty awful if the installer doesn't have a good knowledge of the physics of sound. I just re-installed all of the gear at a large new ballroom in the bay area. Four SRX715 tops and a pair of VRX single 18" subs. Whoever did the original install pointed all of the tops at the middle of the room and hung the subs directly over the spectator seating OPPOSITE the big screen video. In sounded like a wreck in a subway tunnel. I rehung the subs and tops on the video screen side long wall, properly arraying the tops two per side, configured the driverack for mono/stereo/mono and redid the speaker wiring. Fired it up and watched the owner's jaw drop.
 
Greets, Brother Cam.

The Pyle, AA and Gemini brands tend to overrate components by a considerable margin. A very considerable margin...

From reading your comments I get the impression that lack of amp headroom and insufficient SPL may be part of the issue with this system. Since the gain structure and EQ were all fouled up there may indeed be some damaged drivers out there on the prarie. Underpowered, inexpensive amps coupled with indifference on the part of the operator(s) can do that.

If the house owner is receptive to your repairing the system and getting it up to snuff, you may wish to draw up a few scenarios and discuss them with the management. Be sure to do a full inspection of the existing equipment and determine what may be needed. Mention the pros and cons of each option as you suggest them.

Start with a basic, no frills repair estimate. Then move up to a partial upgrade, ie repairing the existing speaker systems and replacing the low amp with one that is capable of handling the bass etc. Lastly, a full replacement cost.

What you end up doing will depend upon the owner's ability to finance it. This is why I recommend working up options and discussing 'em with the owners.

The active crossover, Compressor/Limiter and EQ should be set properly and locked away where they cannot be monkeyed with. A C/L is a must-have for this situation as it may be used to place a ceiling on the system output to prevent it from being overdriven (again). If there is no C/L in the system, I recommend getting one.

Hope it helps.
 
Its hard to make good sound in A bowling alley they arent designed for that just for noise in the background

he is clueless how bad everything sounds
Its going to be a hard sell for this reason

For the average person going in to the alleys they dont know and dont care how bad it sounds just the noise is there

Without knowing the size of the place here is what I would suggest ( I am using the assumption there are 32 lanes like we have here)

Fly one JBL over every 4 lanes. Instead of the Eons I would go passive to make use of the gear they have there. Go with the JRK series they are very cost effective and provide good tone used properly

Providing they are not blown rig the CV subs one over every 8 lanes. I own both the CV subs and the JRX subs the CVs would blow the JRXs away

Use the 2 gemini amps to power 4 of the JBL tops and find 2 more either gemini or something of equal specs to power the other 4. I say this to make use of what they have if you have the budget go better

Find a couple of used QSCs to power the CVs.

Again as Fred said make sure you are using a limiter and its locked away with the EQ and any other processing gear

Or you could sell it all to some poor unsuspecting DJ and start from scratch:sqlaugh:
 
sounds like the perfect job for a driverack PA which can be locked down.

Also have you considered DJing at this establishment, it could be a source of income for you as well as exposure for the bowl-o-rama and you!

The driverack is a good idea.

I plan to inspect all existing gear, and put together a repair plan.

I plan to put together a few install options for partial upgrade as well as complete replacement.

As for DJing at the place, I have more work than i can handle now, if I can find a decent dj to hire for my company it will be an option.
 
I tend to agree. A Driverack unit may be just the ticket for this venue. Set and forget. :)
 
I'll bet if you just figure out which speakers are blown, unhook them from the system, then rewire correctly the stuff that does work, you could make that system sing without adding more equipment to the mix!

I know I could, anywayz . . .
 
Make your efforts calculate Wise....
Do as little selling of components and fix as Doc said as much as you can to get most for the money. You may have a great place to train newbs or atleast make a few bucks playing music there in the future especially those lean months.