Powered Speaker question

To many ads? Support ODJT and see no ads!
Stupid question but can you hook up 2 entirely different brands of powered speakers together and make them work? I have a 400 person reception coming up and need to rent additional speakers.

Not a stupid question at all. Yes you can do that. Split the signals coming from your EQ if that is the last item in the chain before the Amp/Speakers. Use a pair of Y Connector Cables to do this. Male to two females for each side, left and right.
I would not daisy chain from the speaker themselves (Unless the connection was parallel) for two reasons. If one speaker goes down the other in that chain can be silenced.
 
Not a stupid question at all. Yes you can do that. Split the signals coming from your EQ if that is the last item in the chain before the Amp/Speakers. Use a pair of Y Connector Cables to do this. Male to two females for each side, left and right.
I would not daisy chain from the speaker themselves (Unless the connection was parallel) for two reasons. If one speaker goes down the other in that chain can be silenced.

yeah, second that emotion!
unless of course, the cable run is too darn long.
also, since you are running POWERED speakers,
check the back of your mixer or EQ.
if it has 1/4" and XLR outputs...you can send one pair to each speaker set.
 
shouldnt be a problem....havent done it, but it should work fine. If you are super picky about sound, it may not sound absolutely perfect/matched, but then again with a big enough area, timing/delay/echo will be an issue no matter what.

I run signal from my powered tops to my other powered tops now and again....works fine with a regular good quality XLR.
 
I do it many times. Most powered speakers have In and Outs for connecting in parallel. I go from my main speaker (output) to the Input of the other speaker. Adjust the secondary speaker volume to match those of your primary (listening level). Most Active speakers have independent volume controls.