Houston where do you buy your connectors and cable? I usually go with partsexpress or markertek, just wondering if you know of any other good places to check out for that stuff.
First, if you want custom built Cables with these type of connectors call Ben, he can make them for you.
Right Angle Female:
(Fixed) http://www.parts-express.com/pe/showdetl.cfm?Partnumber=092-026
(Adjustable)http://www.zzounds.com/item--NTKNC3FRC
Right Angle Male:
Fixed: http://www.parts-express.com/pe/showdetl.cfm?PartNumber=092-025
Adjustable: http://www.zzounds.com/item--NTKNC3MRC
The cable was purchased at a local Electronics supplier by custom cut length i.e. by the foot!
My female adjustable connectors also come from here: http://www.ebay.com/sch/i.html?_fro...le+Female+connector&_sacat=See-All-Categories
More: http://www.amazon.com/Neutrik-NC3FRX-B-Right-Female-Contacts/dp/B00067JJ9A
When soldering the contacts make sure you know what you are doing (Dropping a blob of solder on the contact does not constitute a good solder joint, it is actually a "Cold Solder" which would eventually pop loose).
Cut the bare ends to the point that the wire insulation covers the wire up until the point of the solder joint with no excess wire showing to cause a short out. The joint should be nice and shiny when done. Clean all solder joints with Industrial Alcohol when finished to wash away excess flux.