Cart for RCF sub

To many ads? Support ODJT and see no ads!
His is mounted on the back like the original RCF cart. I've attached a photo of the RCF model...

- flip back your sub
- trace it onto the plywood & cut it out
- measure the section for the amp module and cut it out
- drill two holes for the bolts to go through to the existing threaded holes of the sub
- mount castors (mount bolts flush into wood using tapered heads)
- stick on some pieces of the thick industrial felt padding so the cart doesn't come into contact with the sub. They used round felt pads on the other side of the wood behind the wheels.
- bolt on
- away you go!

If I were to make one, I would just make one to fit the bottom and cut out holes so it would fit over the rubber feet. I would use four corners of industrial strength velcro to fasten it on, then it could be removed whenever and there would never be any flipping of the sub. Moving it upright would allow you to use your existing cover, if you have any and you could also pile stuff on top of it for transport. Hmmm, that sounds good to me, I think I'll make one too!:sqwink:
 

Attachments

  • RCF back plate Quick e-mail view.jpg
    RCF back plate Quick e-mail view.jpg
    28.4 KB · Views: 0
don't cheap out on the casters!! 4" is best,,, I see so many DJs with these itty bitty wheels because they didn't want to spend the duckets....
 
remember guys...I have an 80lb sub vs the 120 lb 4pro...

I think when I secure it...I'll use rubber nubbers (to space the base to the sub).. How thick is the plywood Jay? Could you use melamine....

Sh-ite....I just realized...with the base, I can't use the cover !!! Crap ! Steve...you might have a plan

I'll have to rethink this...perhaps a cart that is not permanently attached...or a 3 sided cover.....
 
If your cover is open on the bottom and drops over the top of the sub, it will also fit if the sub is tipped up onto the caster board. The top and front dimensions are the same. If you have a cover with a full flap closure then you will indeed have to figure something else out.
 
Hey, I could do that...

I have a wood shop in my garage. Trace an exact size of what you want (mark all the holes) onto a large sheet of paper (paper rolls that you can buy for covering butcher tables works good). I'll make you one or two, and you send me funds via paypal.

4 inch casters (good ones) run about $10 - $15 each and a sheet of plywood runs about $20. Shipping would run about $12 - $15. That works out to about $75 for each one (cost). I'll try a few at no profit to see if it is "do-able". I'll even paint it black for you.

How much is the "factory" unit shown in the above post? You might be better off buying that one???
 
RCF provides 3" Guitel casters with the factory boards. For the ART705AS, one complete caster board using factory components should cost about $110 plus shipping. Recently I've been sourcing the wheels cheaper elsewhere, and the price for a single board would be about $95 plus shipping.

Mike Pyle
Audiopyle Sound
 
$45 bucks.........and the satifaction that I actually built something that looks ok...

Mike it was brought up that the wheels could kick dust/water up into the amp.... Any concerns...i thought of velcro'ing a flap while transporting....

Good idea. You could stitch velcro to the top and bottom edge of the cover opening, then use a flap wide enough to cover the amp module. It would secure the cover to the sub at the same time.

I think I'll start ordering my covers like that from Undercover.

Mike Pyle
Audiopyle Sound