Novascans in Master/Slave Mode

To many ads? Support ODJT and see no ads!

HiDefDJ

New DJ
Aug 13, 2006
2,150
0
47
I need to put my nova scans in master/slave mode. I have 2 of them. I lost the sheet that said how to do it. Please help.:sqlaugh:
 
Right place bunkey... I mean that in a good way!!!

Master/Slave Music mode
- Be sure AC power to all units is off before continuing next steps.
- Daisy chain your units via the XLR conductors on rear side of units. Remember that the Male XLR connector is the input
and the Female conductor is the output.
- The first unit is the chain (Master) will use the Female XLR connector only. And the last unit in the chain will use the
Male XLR connector only.
- Set (Master Unit) dipswitch #10 on only, all others off. All other (Slave units) set dipswitch #1 on only, and all others off.
- Be sure only (Master unit) has dipswitch #10 on, and not any of the (Slave units) to prevent damage to units!!!
- Plug units into AC power source.
- Units will run in sync operation by sound being picked up by the microphone in the unit.
- The RED LED located near dipswitch will pulsate to audio beats on (Master unit) only indicating audio signal being
detected and flash constantly on (Slave units) indicating the unit is receiving signal.
- See Master/Slave dipswitch chart section #8 for settings.
 
While setting up last night I forgot that I had my nova scan manual in the arriba bags with my fixtures. lol

I ended up NOT linking them and having each light run independent all night. It worked out better IMHO because the last time I did link them in master/slave I wasnt' impressed. I had the fixtures about 4 feet apart on my truss so there was no seperation between the beams. At least with running them independently one fixture was shooting one way with color while the other was the other way.

Thanks guys!