Projector Question

To many ads? Support ODJT and see no ads!
G

Guest

Guest
I read the specs that Basic posted however these seem a little different in terminology and I wanted to ask what they mean.

LCD Projector Specifications:

- Power Adapter: DC 12V, 5A
- Luminous Flux: 200-300 lm
- Brightness Uniformity: 75%
- Resolution: 480 x 234
- Display size: 12 - 80 inches
- Effective Distance: 0.6 m - 5 m
- Best Display Size: 48 inches
- Sound: < 30 dB
- S-Video Input
- Stereo Earphone Output
- Adjustable Focus
- Adjustable Volume, Brightness, Contrast, Chroma
- Remote Control on all functions

- Projector size: 235mm(L) x 218mm(W) x 90mm(H)

Would this be considered good, bad, average?

Is Luminous Flux the same thing as Lumens?

Thanks
 
this doesn't seem to be all that great. What are you looking do to with the projector? It only produces an image just over 6'.

It'd be better if you provide a link to what you found.
 
>Resolution & >Lumens = >$

Dan, what they are saying is that there is an external wall wart or brick (power supply) needed and most probably supplied for the unit. The device is small but you still have to carry that external supply too.

Luminous Flux, from a quick bit of research to double check is measured in lumens. The typical measurement for most units is greater than 800. Top end is around 2000 (this is for units mere mortals can carry and afford) lumens. The larger the picture and/or the greater the ambient light the higher should be the lumen rating of the projector used.

The resolution is the number of pixels across and down that can be projected. VGA resolution is 640 X 480. SVGA is 800 X 600. XGA is 1000 X 800.

The more pixels resolution, more brightly shone, the more money is extracted in exchange.

BTW are you sure the resolution you posted wasn’t some odd operational mode rather than the native resolution? The native resolution should be a minimum of VGA or 640 X 480. Most modestly priced units today have SVGA resolution.

To answer you question Carolyn, a step above a toy unless there is something special not shown in the specs. The recommended screen size is 48". Given the lumen output, the ambient lighting should be subdued. Resolution has been, even in the most modest of projectors, VGA or better. As near as I can quickly determine luminous flux is the same as lumens but have not yet found a source to authoritatively confirm that. My guess is that it is close enough for government work.
 
Thank you for answering my question.
By the way I copied and pasted the specs.
I was looking for a projector so I can start doing photo montages.