Clean those fans!

To many ads? Support ODJT and see no ads!

Dan The Man

Administrator
Staff member
ODJT Supporter
Jul 20, 2006
15,208
7,547
42
New York
dantheman.me
Here is an example of how you should not treat a computer. I opened up my case a week or two ago to check on a loose drive. Now, I cannot even get all the crap off the fan. I'm going to buy a replacement after the holidays. I now know why my computer sounds like a jet fighter taking off when under some load. :sqerr:

Something to think about for both your home and Mobile DJ rigs.
 

Attachments

  • DSCF3107.JPG
    DSCF3107.JPG
    40.6 KB · Views: 4
  • DSCF3108.JPG
    DSCF3108.JPG
    64.2 KB · Views: 3
  • DSCF3109.JPG
    DSCF3109.JPG
    39.1 KB · Views: 3
  • DSCF3110.JPG
    DSCF3110.JPG
    78.4 KB · Views: 1
  • DSCF3111.JPG
    DSCF3111.JPG
    67.4 KB · Views: 3
Yikes! Those fans are definitely due for some maintenance. :sqerr:

Coreen periodically pulls out the towers on both our PCs and opens them up and gives the fan and other areas a blast of canned air.

We too suffer with a house with two cats that let us live here! :D

Kirby
 
Ironic that you should post that......

For the last couple of weeks I have smelled something "hot" in my office (which doubles as my wifes sewing room) and by a process of elimination I found that I had a burnt fan in my main machine.

I replaced the fan but the insides looked just like that. $12 fan, $10 canned air, computer no longer smoking, priceless.
 
Yes - Don't forget to clean out the filters and fans on your amps too....

But silly question Dan - Do you use gas or oil heat??? I've noticed a lot more dust with oil.
 
The mung that collects on fans, power supplies and even the motherboard on occasion is made up of the worst stuff on earth. It's made up of dead skin, hair, pet dander, smoke particles, dust mites and an assortment of other nasties. For proper cleaning, remove the fans and power supplies to use compressed air. For the motherboard and other electronic components, you do NOT want to used compressed air, rather a soft, non-static collecting brush will do the job.

Compressed air leaving the nozzle of a can, number one drops considerably in temperature (as much as 20 - 30 degrees cooler) and the air being forced past a restricted opening also ionizes the air (giving it a static charge). It only takes 30 Volts ESD to turn you computer into an expensive paperweight...
 
After blowing the fans, I wipe them down with industrial grade alcohol ( NOT standard rubbing aclohol- too much water in it)

To clean boards, do it like the pros ( I was a board stuffer for some time) Now that Tri-chlor is no longer available, use that same industrial grade alcohol and a brush made specifically for the purpose. A cloth may snag a component or lift a chip pin without you noticing it.