angled XLR adapters

[rickryan.com]

Does anybody know of anyone who makes an angled XLR female plug that has the top hole going AWAY from the angle? Here's the standard plug that everyone seems to have:



The little yamaha MG10xu mixer that I'm using has male sockets but the way they're oriented, it puts the cable going right over the master bus on the mixer.

 

[steve149]

The Neutrik assembly instructions show the barrel can be rotated up to 145 degrees, so you can get within 45 degrees of what you want ...

The Switchcraft R3Mz appears to be able to be put together at any angle.

 

[DJCC]

Zzounds.com


http://www.zzounds.com/item--NTKNC3FRC

 

[steve149]

I think the issue is the Neutrik can't be put together with the 3 holes in the opposite orientation (middle hole up vs down) .. whereas the Switchcraft one appears to be able to.

 

[DJ SVO]

As Steve said Neutrik does the job. Just read Steve's second post he seems to know this better.

 

[DJCC]

You can file a notch in the Nuetrik and make it work.

 

[DJ Wes]

Can you remove the two screws on the mixer and rotate them?

 

[ahoustondj]

Neutrix Connectors can be wired and turned to any of 7 selectable positions. I Use these on my Live Mixer to go sideways. Notice the Orientation of my XLR Main Outputs (Top Right)
https://fbcdn-sphotos-f-a.akamaihd...._=1425711918_d11cd97e971b7cee6584bb5e3a8e781d

http://www.directproaudio.com/neutr...e-connector/?gclid=CKr7u6-s0MICFchcMgod1RIAOA
Female Male

 

[ahoustondj]

Can you remove the two screws on the mixer and rotate them?

DON"T. If the interior connecting wires are not long enough to turn/twist, you may have to resolder the wires or if it is on a Circuit board you will disorient the pins. Either way you run the risk of a cold solder.

 

[rickryan.com]

Can you remove the two screws on the mixer and rotate them?

Why didn't I think of that?

 

[DJ Wes]

Because you are not as great as I.